Hi ROOTers,
I think this question has been asked before, but I couldn't
find an answer in ROOTtalk, or in the documentation. I've generated a
geometry to be viewed in a TView and the x3d viewer, and in the latter
case is it possible to set the actual x,y,z point the geometry is viewed
from? I need to do this because the origin is the optimum viewpoint for my
geometry, but the default viewpoint is outside the actual volume of
interest.
I know one can use the ExecCommand method to move through the view,
but it's not particularly accurate. Any advice would be gratefully
received! I'm using ROOT v3.04/02 on a RH7.1 PC. Thanks,
Ben Morgan.
--
-------------------------------------------------------------------------------
Mr. Ben Morgan Tel: 44 (0)114 22 23553 (Work)
Postgraduate Student
University of Sheffield
Department of Physics & Astronomy
Hicks Building
Hounsfield Road
Sheffield S3 7RH
-------------------------------------------------------------------------------
This archive was generated by hypermail 2b29 : Sat Jan 04 2003 - 23:51:24 MET